Application:
1. Apply a very small amount of nail oil or vaseline to the mould prior to first - this helps protect the mould for longer use.
2. Use gel polish or similar thin viscosity gel to fill the mould, using a small old brush is easiest to ensure you get into all the little gaps - if the mould is very intricate fill the mould in 2 or 3 layers curing each layer fully - this is to ensure a full and proper cure.
3. Once fully cured, remove inhibition layer before removing the design from the mould.
4. When removing the design from the mould be careful not to tear or rip the mould.
5. Use a rhinestone gel or nail glue to adhere the design to the nail. Then apply topcoat around the design and to the rest of the nail to seal the design. Cure
6. Ensure to thoroughly clean the mould after use and place back in the box to keep it clean and dust free, ready for your next use.
Keep moulds away from direct sunlight to prevent yellowing and damage.
